Guest wlan to VLAN in AP mode in Deco M9+
How the guest wlan isolation has been implemented in AP mode in deco M9 latest firmware for v1 hardware?
Does it have VLAN id and what is it? Why it cannot be set from user interface?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@GeorgeBark no, my solution is to run the guest WiFi connected to the guest vlan from my routers WiFi only and for my work laptop that's too far away for the guest WiFi so I have used ethernet over power.
Down side is my home WiFi has great coverage, but the guest is as bad as it was before... Where if they just sorted the vlan out so its over the Decos and output to the router I could have great for both.
- Copy Link
- Report Inappropriate Content
+1 for VLAN tagging in AP mode in both Guest and iOT networks
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I'm looking at Firewalla's new access point - it supports zero trust and VLAN tagging. Firewalla dot com has more info.
based on the lack of response, and the recent stories in the media on TP Link's state sponsorship- I'm pulling my TP Link gear in the next few weeks.
/sigh
- Copy Link
- Report Inappropriate Content
Information
Helpful: 52
Views: 17289
Replies: 85
Voters 52
