I cant seem to get the c60 toact as a wireless router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

I cant seem to get the c60 toact as a wireless router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

tierraman

2020-07-25 14:53:50 - last edited 2020-07-27 05:57:58

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-03-12

I cant seem to get the c60 toact as a wireless router

2020-07-25 14:53:50 - last edited 2020-07-27 05:57:58

I have an archer c60. I purchased it as I have quite a large house and I have a dead spot on my Terraza, I have followed the instructions to set the C60 up as a wireless router. But after set up when I disconnect it from my modem to put it upstairs the internet goes off and I can't connect to the internet. I thought the c60 would connect wireless to my modem and then send a signal to it but that doesn't see to happen. Can someone tell me what I am doing wrong please - I have to say I am not very good with these types of things

Thanks in advance. My email address is thegauchoschool@gmail.com

David

1 Accepted Solution

Kevin_Z

2020-07-27 05:57:41 - last edited 2020-07-27 05:57:58

Posts: 21750

Helpful: 5128

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:I cant seem to get the c60 toact as a wireless router -Solution

2020-07-27 05:57:41 - last edited 2020-07-27 05:57:58

@tierraman

Hello,

Is your modem a wireless modem router? If yes, you may need to enable the WDS feature on the C60 in order to extend your modem's wireless network to a dead zone, please refer to the below setup guide:

How do I use the WDS Bridging function to extend my wireless network?

May this helps.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

I cant seem to get the c60 toact as a wireless router

I cant seem to get the c60 toact as a wireless router

Information

Voters 0

Tags