Wifi Bridge configuration resetting on power failure

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wifi Bridge configuration resetting on power failure

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wifi Bridge configuration resetting on power failure
Wifi Bridge configuration resetting on power failure
2020-07-17 11:32:23
Model: TL-WR1043ND  
Hardware Version:
Firmware Version:

when am using as wifi repeater, on power off the configurations gets reset automatically. What to do?

  0      
  0      
#1
Options
1 Reply
Re:Wifi Bridge configuration resetting on power failure
2020-07-20 03:21:12

@shebees 

 

Theoretically, what you reported won't happen but we will check some details if it is true:

 

1. When there is a power outage then back on, are you still able to access the web UI of the WR1043N, and what is the IP address of it? Did you change its IP to be in the same IP subnet as the main router?

 

2. What is the model number of your main router? Will it be correctly on and connect to the internet correctly after the power outage?

 

3. Please reset the WR1043N and ensure its firmware is the latest, then try to configure the WDS settings again:

How to configure WDS function on TP-Link Wireless Routers

 

May it helps.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options