Slow wifi with Archer A9

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Slow wifi with Archer A9

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Slow wifi with Archer A9
Slow wifi with Archer A9
2020-07-12 12:17:11
Model: Archer A9  
Hardware Version:
Firmware Version:

Hello,

I recently purchased an Archer A9 wireless router and I am having wifi speed issues. With ethernet I am getting 60-70 mbps at all times (which is what my plan is) so there is no issue with the ISP. However with wifi my devices are usually between 10-15 mbps, at times a bit higher but at times even lower, like under 5. I have tried reading online and changing channels/ width as well as disabling WMM but nothing has helped. I have also upgraded to the latest firmware and done a factory reset.

 

Any advice would be greatly appreciated.

Thank You

  0      
  0      
#1
Options
1 Reply
Re:Slow wifi with Archer A9
2020-07-20 08:12:36

@OgiF1 

 

Hello,

 

Sorry to hear the speed is not as good as expected, please help verify some details and we will try to fix it together:

 

1. How did you test this speed via the router? Did you disconnect all the other devices from it and only leave one computer performing the test? How about the wired/wireless negotiation speed on that computer? Please verify it by referring to the instruction: https://www.tp-link.com/support/faq/2265/

Note: For wired negotiation speed, it is the same; while you need right click on local area connection or ethernet. 

 

2. Please refer to the instruction below to narrow down the issue. 

What should I do if internet speed is slow when the device is connected to the TP-Link router?

 

Good days.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options