Archer VR600v + Telstra DECT Phone

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer VR600v + Telstra DECT Phone

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR600v + Telstra DECT Phone
Archer VR600v + Telstra DECT Phone
2020-07-01 02:02:10
Model: Archer VR600v  
Hardware Version: V2
Firmware Version: 1.0.0 0.9.1 v0078.0 Build 170814 Rel.66346n

PROBLEM: Can't receive or dial calls with Telstra DECT handset.

 

I have sucessfully registered the DECT handset to the modem.

If I try to dial out the LED light on the modem appears like it should and there is a dial tone on the phone but it will not ring a mobile phone.

And if I try to call the handset with my mobile phone it just goes to the telstra message bank.

 

Any ideas please?

  0      
  0      
#1
Options
1 Reply
Re:Archer VR600v + Telstra DECT Phone
2020-07-02 07:38:44

@BPA 

Hi, I have checked your issue from our senior engineers.

According to our experience, since there is some limitation on the Telstra Dect, it can only connects their own modem to use.

Good day!

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options