Slave Deco connect to Main Deco via ethernet cable

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Slave Deco connect to Main Deco via ethernet cable

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Slave Deco connect to Main Deco via ethernet cable
Slave Deco connect to Main Deco via ethernet cable
2020-06-23 05:03:33

Hi,

 

i wanted to connect my slave deco to the main deco via Ethernet cable NOT wifi.

 

should i do any special setup? I just literally plug the ethernet cable and the slave deco still shows the signal source as wifi

  0      
  0      
#1
Options
3 Reply
Re:Slave Deco connect to Main Deco via ethernet cable
2020-06-23 07:59:14
Depends on the Deco unit you have. With the M5s I have, I set them up to the same network by Wifi first, then just plugged in the one I wanted on ethernet. It automatically connected the backhaul over wired.
  0  
  0  
#2
Options
Re:Slave Deco connect to Main Deco via ethernet cable
2020-06-23 14:05:57

@iam_h Reboot slave Deco with inserted eth cable...

  0  
  0  
#3
Options
Re:Slave Deco connect to Main Deco via ethernet cable
2020-06-23 14:56:38

@iam_h  I have a CAT6 cable between master M9+ and slave M9+, I just set it up with Wifi first and measured the download speed, then connected the CAT6 cable and measured the download speed again. The difference was obvious, the cable is used.

  1  
  1  
#4
Options