TL-WR940N V6, no icmp and remote access on wan after enable IPv6.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-WR940N V6, no icmp and remote access on wan after enable IPv6.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-WR940N V6, no icmp and remote access on wan after enable IPv6.
TL-WR940N V6, no icmp and remote access on wan after enable IPv6.
2020-06-12 18:58:33
Model: TL-WR940N  
Hardware Version: V6
Firmware Version: 6

After enable IPv6 on pppoev6/slaac or pppoev6/dhcpv6, the router loses remote access previously configured and stop to respond icmp packets on wan.

If i enable or disable SPI firewall or enable or disable the DOS protection it start to work again, but after reboot it stops to respond again.

  1      
  1      
#1
Options