Deco M5 satellite node always connecting to master node instead of a nearer satellite node
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a Deco M5 mesh network with one master node and 2 satellite nodes, say satellite_node_1 and satellite_node_2.
The node satellite_node_1 has good signal from the master node and no issues here.
And my node satellite_node_2 is nearer to the satellite_node_1. But still it is always getting connected to the master node which is more far, and thus having weaker signal.
How can I make my satellite_node_2 connect to satellite_node_1 instead of the master node?
Regards
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Update：
The official firmware 1.6.0 for Deco M5 is ready and it supports customzing signal source.
For more detailes, please refer to this link:
Thank you very much.
Best regards.
--------------------------
Deco X50-PoE is ready for your advice. If you are interested, please help us complete the following survey.
- Copy Link
- Report Inappropriate Content
Try rebooting Satellite_node_2. It should connect to Satellite_node_1.
If not, try repositioning Satellite_node_1 and/or 2 in such a way that Satellite_node_2 detects a stronger signal. (See picture for signal strength.)
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@DiceKey I have the same problem and moving closer to the nearest node (node1) doesn't help cause that means I have to unplug node2 and closer to node1 still connects to master node. There really should be a way to manually change this.
- Copy Link
- Report Inappropriate Content
Update：
The official firmware 1.6.0 for Deco M5 is ready and it supports customzing signal source.
For more detailes, please refer to this link:
Thank you very much.
Best regards.
--------------------------
Deco X50-PoE is ready for your advice. If you are interested, please help us complete the following survey.
- Copy Link
- Report Inappropriate Content
@TP-Link same issue as well but have 6 deco's that need to daisy chain but refuse to! Support suggested I factory reset slave 2 then connect slave 2 to slave 1 using an Ethernet cable. Verified it was connected via cable and then disconnected. Slave 2 then reconnected directly to the main deco again ignoring slave 1. Interested in getting beta for manual selection?
- Copy Link
- Report Inappropriate Content
Hi, I suggest we can have a try of the beta firmware, and please check your email box.
Thank you.
- Copy Link
- Report Inappropriate Content
@TP-Link I have the same issue could I try the beta please. I have a 5 deco setup and annoyingly all want to be connected to main deco
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 9176
Replies: 38
Voters 1
