Lan IP (DHCP Range keeps changing)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Lan IP (DHCP Range keeps changing)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
My DHCP Range keeps randomly changing I am using a Deco P9 and everything will be working then suddenly it will cut out for a few minutes then I will just get presented with my Lan IP (DHCP Range) will change for example it started on 192.168.68.XXX then it moved to 192.168.0.XXX and now it seems to be on 192.168.3.XXX
Has anyone else experienced this issue as it's now driving nuts and just randomly happens
Cheers,
Rob
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, Could you please refer to the recommended solution to check whether there is an IP conflict?
At the same time, it would be highly appreciated to provide me some details about the network diagram/usage scenario so that we would improve the IP conflict detection mechanism;
Thank you very much.
- Copy Link
- Report Inappropriate Content
This is happening to me on a DECO AX5700. Spent $400 in a buggy product.
- Copy Link
- Report Inappropriate Content
@TP-Link For the sake of the thread I'll just post a crude diagram of what I assume is a very normal setup. Not sure if you're after something way more complicated (with IPs of everything and hostnames, device type, etc. there would be over 30 things on my network which is all the smart home stuff) but I can't imagine how any piHole setup would be much different than this... and not able to be solved many years after product release. Here I am on this board 6 months later and still no progress on patching this. Most of us aren't IT experts. If I'm reading the issue correctly, the DNS needs to be hardwired on LAN for the IPs avoiding conflicts? I've always assigned a static IP to my piholes with the last number available on DHCP mask (usually 255)
https://imgur.com/a/kFvQ16e
- Copy Link
- Report Inappropriate Content
@TP-Link so a pi-hole cannot work with a Deco?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Happens to my M9+ too.
When the Main Deco reboots, the local IP changes too (from my setting to -->> 192.168.0.1).
Add to that--- when my internet goes down fo a moment (power interruption or ISP fault), the main deco remains with red LED lit (no internet). It will ONLY go green (with internet) when I remove for a few seconds the Ethernet cable connecting the Deco to my modem. After this, my Deco assigns a new local IP address (usually 192.168.0.1).
- Copy Link
- Report Inappropriate Content
Can't believe this still has been resolved, I've moved on from my Deco's now. I've moved over Asus as the firmware on these Deco's were always really buggy. Never buying a set again.
- Copy Link
- Report Inappropriate Content
@noelicus But you still have to use something for the DNS servers on WAN, and you can't use the LAN IP.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Bob111 HI, I haven't been told Archer router might have the same logic as Deco and could you please have a look at this link and check whether your current issue is like this:
Cannot set DNS server to a local subnet address
If not, it is suggested to start a new thread with more details.
Thank you very much.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 5147
Replies: 21
Voters 0
No one has voted for it yet.