RE200 - Access Point Mode - Won't operate when DHCP is disabled

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RE200 - Access Point Mode - Won't operate when DHCP is disabled

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

SHayes

2020-03-26 17:47:42 - last edited 2020-03-31 11:09:00

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-03-26

RE200 - Access Point Mode - Won't operate when DHCP is disabled

2020-03-26 17:47:42 - last edited 2020-03-31 11:09:00

Model: RE200

Hardware Version: V2

Firmware Version: 1.1.5

Setting up this device is one of 3 access points in my house.

One of the other devices is an Archer, and works just fine.

On all access points, I assign a static IP from my main router, and disable DHCP - so that all DHCP is served from the main router.

When I disable DHCP, the unit stops working and assigns a random IP address not within my configured range.

Is DHCP server on the RE200 mandatory when operating in Access Point mode?

1 Reply

Kevin_Z

2020-03-31 11:07:04 - last edited 2020-03-31 11:09:00

Posts: 21748

Helpful: 5124

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:RE200 - Access Point Mode - Won't operate when DHCP is disabled

2020-03-31 11:07:04 - last edited 2020-03-31 11:09:00

@SHayes

Hi, you can disable the DHCP server on RE200 when it works as an access point. But you need assign it a static IP address which is in the same subnet of the main router.

The RE200 needs to connect to the main router by wired cable in AP mode.

Besides, the RE200 supports smart DHCP, with another DHCP server detected in the same network, it will disable DHCP server automatically, vice versa.

Good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

RE200 - Access Point Mode - Won't operate when DHCP is disabled

RE200 - Access Point Mode - Won't operate when DHCP is disabled

Information

Voters 0

Tags