deco m4 : Upgraded to latest firmware and my whole system is unusable
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.deco m4 : Upgraded to latest firmware and my whole system is unusable
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Everything was working fine
Till i upgraded to latest firmware.
ever since then my connection is super unstable. The speeds im getting are 1mbps sometimes in my 100mbps connection.
I just to downgrade my firmware to factory default
why on earth does tplink not have that feature built in ?
can someone pls tell me how do it.. i asked support a bunch of times and im not getting any response
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello, sorry about that.
Please help verify more details and we will try to figure it out ASAP:
1. What is the current network topology/layout? How are the three Deco M4s connected?
2. With your computer connected to the modem directly, please verify the actual speed you can get via speedtest.net. Also, please confirm the wired link speed as the instruction below:
https://www.tp-link.com/support/faq/2265/
Please then connect your computer to the main deco and test the speed you can get from it via speedtest.net as well and check the wired link speed.
Note: Please show us a screenshot of the speed test result.
Additionally, please refer to the below troubleshooting to check the QoS settings on the Deco app again:
https://www.tp-link.com/en/support/faq/2429/#case%201 (Case 1)
After that, please run the speed test again and check whether it improves.
Good days.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 4092
Replies: 11
Voters 1
