TP Link stops working when i switch the lights on

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2020-02-23 19:45:05 - last edited 2020-02-24 09:31:28

Posts: 7

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-02-09

TP Link stops working when i switch the lights on

2020-02-23 19:45:05 - last edited 2020-02-24 09:31:28

Model: TL-WPA4220 KIT

Hardware Version:

Firmware Version:

My TP link works fine until i switch on the lights then it stops working.

Switch them off and instantly connects again so i know this is the problem.

Has anyone had the same problem and if so did you find a fix for it.

Model is WPA4220

1 Reply

2020-02-24 08:48:21 - last edited 2020-02-24 09:31:28

Posts: 21773

Helpful: 5142

Solutions: 2574

Stories: 21

Registered: 2018-12-24

Re:TP Link stops working when i switch the lights on

2020-02-24 08:48:21 - last edited 2020-02-24 09:31:28

Hello, how did you switch on the LED lights?

Have you ever tried to hard reset by holding the reset button/hole for 10s with it powered on and then re-pair them?

Good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.