Extend network over ethernet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Extend network over ethernet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Extend network over ethernet
Extend network over ethernet
2020-02-22 19:33:45 - last edited 2020-02-24 05:56:29
Model: TL-WA901ND  
Hardware Version: V5
Firmware Version: 3.16.9 Build 160929 Rel.37753n

I have an existing ethernet and wifi network setup through a bluecurve router.

I am trying to extent the existing wifi network to increase the wifi range. I need the SSID to remain the same, and the device to be able to connect to the strongest wifi network.

Is this possible with this device? I have contacted support but only get the generic emails in return, none of which are helpful.

 

I am trying to link a wireless printer onto a wired network in an area where the original wifi range can not reach. A separate SSID will work, but I then can't connect to the printer over the network. I've used the setup wizard, but it prompts to create a new ssid and password through the ap bridge setup.

Any ideas???

  0      
  0      
#1
Options
1 Reply
Re:Extend network over ethernet
2020-02-24 05:56:17 - last edited 2020-02-24 05:56:29

@Jess1972 

 

Hello, do you want to connect the TL-WA901ND to the main router by wired cable to boost wifi signal or connect to it by wifi? 

 

If you want to connect them via wired cable, you can configure the TL-WA901ND as the access point mode. 

https://www.tp-link.com/support/faq/1603/ 

 

Otherwise, you can follow the instruction below to configure it as a range extender. 

https://www.tp-link.com/support/faq/1604/

 

And you are able to customize the wireless settings: https://www.tp-link.com/support/faq/399/

 

May it help. 

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options