Troubleshoot (Adding new powerlines)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Troubleshoot (Adding new powerlines)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Troubleshoot (Adding new powerlines)
Troubleshoot (Adding new powerlines)
2020-01-30 01:07:03
Model: TL-PA4010 KIT  
Hardware Version:
Firmware Version:

I currently have 3 powerline adapters connected to the main one. 2 TL-PA4010's and 1 TL-PA4010KIT. I tried adding a new 4010KIT to the circuit and it works fine. however all the other powerline adapters have stopped working. All they say is Unidentifed network. 

  0      
  0      
#1
Options
1 Reply
Re:Troubleshoot (Adding new powerlines)
2020-02-02 09:54:22

@TheOrangePea 

 

What is the led status of the TL-PA4010 units?

 

You can reset them by holding the pair button for 15 seconds and re-pair them via the tpPLC utility.

 

Below is the instruction: https://www.tp-link.com/uk/support/faq/1615/

 

May it help.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options