Need help with placement

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Need help with placement

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TheSam

2020-01-20 20:37:11 - last edited 2020-01-21 07:49:20

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-01-20

Need help with placement

2020-01-20 20:37:11 - last edited 2020-01-21 07:49:20

Model: Deco E4

Hardware Version: V3

Firmware Version:

Hey there,

Would apreciate any help in placing my deco. Just bought them to try and boost my 250mbps service, as with powerline this drops ridiculously to 50mbps only.

I have my router/modem near my tv in the living room. I wanted to place my 1st slave in the main bedroom and 2ns slave on my desk in my "office". However, 1 & 2 dont seem to connect to the main due to the distance and possibly the walls. Attached is a small and rough (very rough) diagram of my apartment layout.I was think of placing my main further away from any interfering signals such as the tv and erhaps the 1st slave in the kitchen, hopefully then being able to reach my 2nd on the office desk.

Also, when i succesfully managed to set up the main, speed went down from 250 to 90, and this directly connected. Any ideas here?

Many thanks in advance

1 Accepted Solution

Kevin_Z

2020-01-21 02:04:33 - last edited 2020-01-21 07:49:20

Posts: 21569

Helpful: 5032

Solutions: 2542

Stories: 21

Registered: 2018-12-24

Re:Need help with placement-Solution

2020-01-21 02:04:33 - last edited 2020-01-21 07:49:20

@TheSam

Hello, what is the distance between the Deco units? Per you said, due to the distance and walls, the signal strength obtained by slave Decos may not be good enough.

You can try to move them closer to each other;

Regarding to the speed issue, the Deco E4 has the 100Mbps LAN ports, that is why the speed slows down to 90Mbps. You can exchange another Deco product that supports gigabit LAN port, like Deco M4, Deco m5.

https://www.tp-link.com/support/download/deco-e4/#specifications

HARDWARE FEATURES
Ports	2 10/100Mbps, WAN/LAN Ports, 1 Power Port

May it help.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Need help with placement

Need help with placement

Information

Voters 0

Tags