Time Machine setup
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I'm not able to setup Time Machine to use my share drive on a AX6000... TP-Share is working, i can see and explore the entire disk... with or with out access secure (using U/P). When I try to connect the disk on Time Mchine, ask to login at Archer 6000! Using admin/admin seems to work (connexion a Archer 6000) but after a while, end up with error message "Time Machine unable to connect to backup disk (L’opération n’a pas pu aboutir. (OSStatus erreur 2.)"
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Same thing for me... Always lose W&R option... and nobody understand why...
- Copy Link
- Report Inappropriate Content
Is there the same error message "Time Machine unable to connect to backup disk" as other users mentioned when you try to access the backup on the MacBook?
May I know the brand and capacity of the HDD connected to the AX6000 USB port? Have you tried to reformat the HDD to ExFat? Is the USB sharing working?
You can try to refer to matt_film's steps on #7? Will it work?
- Copy Link
- Report Inappropriate Content
I've identified the problem and notified TP-Link tech support. While it's on my AX6000 I am pretty sure it's across all platforms. The problem is that by default, if formatting HFS+ extended (both case and non case sensitive) it also formats journaling. The router cannot handle the journal, and overwrites it corrupting the filesystem. To fix, disable the journal. On your mac after formatting, mount the drive and get a command line (open terminal). Assume that your drive is named NameOfYourDisk. nter the following command at the prompt:
diskutil disableJournal /Volumes/NameOfYourDisk
Eject the drive and then attach it to the router - that should do the trick. Obviously, test this yourself on something that does not have important data as formatting will wipe it.
And equally important - without the journal, a power outage or reboot while the disk is being written has a chance of causing filesystem damage that you will need to connect to the mac to fix.
Typical disclaimer applies: I'm not a TP-Link employee, and your milage may vary, but it's working for me.
- Copy Link
- Report Inappropriate Content
By the way.. for everyone that says the various solutions that don't involve disabling the journal work - have you tested your backup? By tested, I mean power cycle the router, then restore a file or 20 from your backup. I thought everything was fine until I rebooted the router. When I connected the drive to my mac directly, it reported disk errors it could not fix.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 7457
Replies: 24
Voters 0
No one has voted for it yet.