@Koeno 

On the 1.2.12 beta i had that features enabled, but now i have better iptv settings and a option to disable the UPnP

@e3henri 

My deco devices came with the 1.2.11 version.

for what i understand the new update 1.2.13 is for the new V2 devices 

avniel wrote

@Koeno 

Is it complicate to do? 

@avniel 

No not difficult, use the tool and binary from one of the posts in this thread. Details how to do it are supplied. You need userid, password, ip adres of Deco and binary update file. See instructions in zip file when you download it.

@SrDarkWarrior 

I'm using the Deco's in AP mode so I don't have the iptv options. I use the beta from post #74. With the app, if I click on a client, then settings, that will show me how it is connected and to which Deco. Similar for the Deco's itself. The web UI gives an overview and is easier

@Koeno 

oh ok thanks for the information :)

im using in router mode

@SrDarkWarrior 

Ok. But I assume that you are now also able to see how clients and Deco's are connected?

@Koeno 

yes, i had that information on 1.2.12 beta too

I did the upgrade to 1.4 around midnight PST last night.  Pretty straight forward using the guide.  I used the mac version.  started with the slaves then master.  After a min of coming back up, i had no internet access.  Rebooted everything to no avail.  I even tried to downgrade the firmware but yielded an error.  I even removed and reconfigured the decos.  Also tried a previous router and had no interent.  Spent over an hour troubleshooting.  Finally i logged into my ISP page and there was actually a serivce maintenance and an outage in my area. lol.  As of this morning everything looks good.  Only some errors in the logs that i have no clue what to make of it via the web GUI.  I was close to ordering the orbi rbk50 the other day becuase of this firmware issue. or lack of firmware upgrade.  i might still do that.

@Koeno 

Hi, if you can help me , I have one question regarding the firmware upgrade.

After upgrading the first deco (the slave) I just need to open the upgrager again and do the next one or should I go over the whole process again with the command prompt etc

Thanks 

Nir

avniel wrote

@Koeno 

Hi, if you can help me , I have one question regarding the firmware upgrade.

After upgrading the first deco (the slave) I just need to open the upgrager again and do the next one or should I go over the whole process again with the command prompt etc

 

Thanks 

Nir

@avniel 

I didn't do the command prompt because I already new the IP addresses of my Deco's. After updating the first I kept the tool open, only changed the ip address to the next one and upgraded again