Ethernet Connection between Modem and Range Extender

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2019-12-03 05:20:00 - last edited 2019-12-03 06:53:22

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-12-03

Ethernet Connection between Modem and Range Extender

2019-12-03 05:20:00 - last edited 2019-12-03 06:53:22

Model: RE450

Hardware Version: V2

Firmware Version:

Is it possible to connect a TP Link Modem (MR400) to a TP Link Range Extender (RE450) by ethernet cable ?

The building I am in does not allow for a strong enough signal between the 2 devices for the range extender to work.

Thanks

1 Accepted Solution

2019-12-03 06:53:14 - last edited 2019-12-03 06:53:22

Posts: 21746

Helpful: 5122

Solutions: 2562

Stories: 21

Registered: 2018-12-24

Re:Ethernet Connection between Modem and Range Extender-Solution

2019-12-03 06:53:14 - last edited 2019-12-03 06:53:22

You can connect the RE450 to the MR400 directly by wired cable. The MR400 works in router mode, and the RE450 works in access point mode.

Below is the instruction to set it up as the AP.

May it help.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.