force device to always connect to a specific deco?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Is there any way to force a device to connect to a specific deco? In my home office I have a TP-Link RE450 extending the Deco's WiFi network, but it always seems to connect to the deco furthest away from it rather (ideally) the one just a few meters away from it in the hallway - or even the (main) deco in the kitchen.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I just took the units back for full refund and went with a different brand. I wasn't getting anywhere with tplink support. Was advised to use ethernet cable to link them together. Thought that totally defeated the intended purpose.
- Copy Link
- Report Inappropriate Content
I can't find the Connection Preference option. I have the X55. Can you tell me where to find this
TP-Link has FAQ document describing Connection Preference feature: How to select a preferred signal source on the Deco App
- Copy Link
- Report Inappropriate Content
Please also make sure your firmware is up to date. And the latest official firmware of Deco X55 is 1.1.0 Build 20221102
Best regards.
- Copy Link
- Report Inappropriate Content
Why isnt this feature available on the higher tier mesh decos?
I have X60's throughout the house and I don't have this option, which is really disappointing.
- Copy Link
- Report Inappropriate Content
I looked at the article that explains how to use the preferred connection approach and it specifically states the devices the article applies to with my model (Deco M9+) included in the applicable device list. However, there is no option mentioned in my Deco App. I double checked the firmware for my units and they are at the latest release.
Where is the option if the article actually is correct?
- Copy Link
- Report Inappropriate Content
NTGm wrote
I looked at the article that explains how to use the preferred connection approach and it specifically states the devices the article applies to with my model (Deco M9+) included in the applicable device list. However, there is no option mentioned in my Deco App. I double checked the firmware for my units and they are at the latest release.
Where is the option if the article actually is correct?
You will need to install M9 Plus beta firmware to unlock that option. Here it is: https://community.tp-link.com/en/home/forum/topic/574954
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Sorry to dig up this old thread, but I have 2 x Deco M4 and I want to add more to the network.
In my local store today they had two three packs. Both were EU V3.
Are you only manufacturing V4 now, and it likely that the store was just holding older stock?
Thank you.
- Copy Link
- Report Inappropriate Content
I have the same issue. I installed the doorbell and it's connecting to the farthest deco. I have 5 deco x20s installed. The nearest deco is Deco4 but it's connecting to the Deco3. Is there any solution to force the client to connect to the specific deco?
- Copy Link
- Report Inappropriate Content
@David-TP is this going to be added to the x60 at any point? my furthest one away alway connects to the living room and drops out but i have one in the middle that it could connect to to get a better signal.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 43
Views: 90284
Replies: 107
Voters 16
