Home

Forums

Stories

Knowledge Base

Home Network Community > Powerline Adapters > I don't get the speed shown on tpPLC

< Powerline Adapters

I don't get the speed shown on tpPLC

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

I don't get the speed shown on tpPLC

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Chuug

2019-08-21 19:04:23

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-08-21

I don't get the speed shown on tpPLC

2019-08-21 19:04:23

Model: TL-PA9020P KIT

Hardware Version: V1

Firmware Version: 170629

Hi,

I have the TL-PA9025P-KIT and I installed the tpPLC because I don't have the speed I should have. As you can see on the picture below, it shows around 1000 mbps but I only get 100 to 150 mbps when I do a speed test. I tried with a direct cable to my router and I get the maximum speed I can get (400 mbps). So I really don't know where the problem is coming from. Why is the application showing 1gbps if I only get 10% of it?

Thank you for your help

1 Reply

Kevin_Z

2019-08-22 07:34:55

Posts: 21750

Helpful: 5128

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:I don't get the speed shown on tpPLC

2019-08-22 07:34:55

@Chuug

Hello, the tpPLC speed is not the actual speed, instead, it is the powerline link rate between the 2 adapters; the speed we can get from is about 30%-40% of it, combined with the interference, the actual speed even be slower.

While cause the current speed is just 10% of it, we can do some troubleshooting on it.

1. The speed you can get from the TL-PA9025PKIT with computer connected to it only.

2. Please click here to verify the wired negotiation speed of the computer.

Note：The steps are the same, while you need right click on local area connection or ethernet connection.

3. Try to move them into the same room to test the speed, or change another wall sockets to plug them.

Below is a guidance you can refer to narrow down the issue.

https://www.tp-link.com/support/faq/2231/

Best regards.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

I don't get the speed shown on tpPLC

I don't get the speed shown on tpPLC

Information

Voters 0

Tags