Tp link Re450 won’t power on after power failure

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tp link Re450 won’t power on after power failure

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tp link Re450 won’t power on after power failure
Tp link Re450 won’t power on after power failure
2019-08-15 12:59:48
Model: RE450  
Hardware Version:
Firmware Version:

I have rebooted router and extender but still will not turn on or connect. Tether does not find device either.

  0      
  0      
#1
Options
1 Reply
Re:Tp link Re450 won’t power on after power failure
2019-08-16 05:42:12

@HelenD 

 

Below are some suggestion you can give it a go:

1. Change another socket  to plug it.

2. Ensure that the LED control button is turned on. Note: We can press it for 1 second to turn on/off all LEDs.

3. With the extender powered on, use a pin to press and hold for 1 second to reset the extender.

 

Still no led on, the extender may be faulty; and you can contact our tech support with serial number, proof of purchase and the thread link to verify whether the replacement is qualified. 

https://www.tp-link.com/support/contact-technical-support/#E-mail-Support

 

Best regards. 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options