So tried the Vigor 130 in bridge mode and router still will not connect, really need a firmware update to include DHCP option 60/61 for sky fibre 

I have exactly the same issue:

My setup:

• Draytek Vigor 130 configured in MPoA Bridge Mode
• TP-Link Archer AX6000

Added Option 61 (Client Identifier*) to the DHCP options on the Draytek and on the TP-Link I cloned the MAC of the Sky Q Box - worked for around 12 hours and dumped me out.

Its worked twice both for 12 hours before uncerimoniously being dumped out.

At the moment I have to use the AX6000 configured in AP mode (hooked up to the old Sky Q Box) which is really annoying as you cannot use most of the features in this mode of operation.

Someone mentioned that Option 60 needed to be populated with Sky Q Box Firmware version but clutching at straws really.

I do not think the TP-LINK Archer AX6000 supports DHCP Option 61 (MER).

M

* You can obtain the Client Identifier by using WireShark, filtering for udp.port==67 and looking for DHCP Discover with Option 61 with a length of 28 Bytes - copy as printable text - remove the leading = and that is you sky client identifier in the <MAC>@skydsl|<password> format.

@Sidney2g Hiya, 

no the only way i got round this was to use my old tp link vr200 in modem only by setting nat forwarding on vr200 and pointing the dmz on the vr200 to ax6000

i also had to change the ax6000 to dynamic ip so it picked up a Internet address on the wan port