Access Control not blocking

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Access Control not blocking

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Access Control not blocking
Access Control not blocking
2019-07-01 04:57:46 - last edited 2019-07-02 02:47:00
Model: Archer VR900v  
Hardware Version: V2
Firmware Version: 0.4.0 0.9.1 v0069.0 Build 171128 Rel.42667n

Hi. I have setup Access Controls, Added Mac address's and switched on the feature however the machine (a laptop and xbox) are still able to access the internet. I cannot understand why? Is this because I have upgraded the firsmware to the new logo firmware?

  0      
  0      
#1
Options
1 Reply
Re:Access Control not blocking
2019-07-02 02:48:24

Hi,

 

Below is the instruction to setup access control on the VR900V.

https://www.tp-link.com/support/faq/1743/ 

 

May I know how did you set it up? Please show us a screenshot of the access control settings page. 

 

Besides, how do you connect the xbox and the laptop to the router? by wired cable or by wireless? 

 

Good day. 

 

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options