Ethernet connections to Deco Units

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Ethernet connections to Deco Units

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Colly100

2019-05-13 07:48:46

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-05-08

Ethernet connections to Deco Units

2019-05-13 07:48:46

I am planning to purchase a Deco home wi fi system (3 units). I have ethernet cable running to the 3 intended locations for the Deco units and will keep my ISP modem router in router mode (but turning off wifi). I understand that I can set up ethernet backhaul by connecting one Deco unit to the modem router by ethernet and then in turn connecting the remaining 2 units to each other in a “daisy chain” system. Is it also possible to connnect each of the Deco units direct to the modem router (in a “star” system? If yes, what are the advantages and disadvantages of each system?

1 Reply

Kevin_Z

2019-05-14 08:41:32

Posts: 21748

Helpful: 5124

Solutions: 2565

Stories: 21

Registered: 2018-12-24

Re:Ethernet connections to Deco Units

2019-05-14 08:41:32

Hi,

You can make your ISP modem router as main router and configure the Deco units as access point and connect them to the main router directly; Like the scenario 2.

https://www.tp-link.com/support/faq/1794/

It still works, while the Deco does not support some advanced features in access point mode, like parental control, anti-virus and so on. But in access point mode, there won't be double NAT issue.

If possible, you can make the ISP modem as bridge and connect the main Deco to it and works as the router mode, and then you can enjoy the advanced features and avoid the double NAT issue.

Have a nice day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Ethernet connections to Deco Units

Ethernet connections to Deco Units

Information

Voters 0

Tags