Deco M5 - NAS support?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello - complete n00b networking questions.
I own a Deco M5 Mesh system and would like to setup a NAS for local (at home) use.
1- Is it possible to do so with the M5?
2 - Is this the best possible way to do it?
If this will work expect further questions during set up 
Thank you all for your time.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
yes, work fine on this way.
Just use Fixed IP on NAS or assing fixed IP into Deco network. (Address Reservation).
- Copy Link
- Report Inappropriate Content
Thanks leogz! I will update this thread in a few weeks to confirm.
- Copy Link
- Report Inappropriate Content
I have my NAS setup like this and it's fine...I actually have the 2 deco pucks on second switch attached to the first. NAS is on the first switch like your diagram.
- Copy Link
- Report Inappropriate Content
I try to set up the same configuration with deco m4r and devices connected to switch are not visible. I check cables and switch with another router and there all works great.
Now slave deco work only with master by wifi ...
What i do wrong ? How to find solution.
- Copy Link
- Report Inappropriate Content
@Foxtrot1987
Hello there. Recently got Deco M4 and want to configure my NAS into Deco in Router Mode.
One question based on your diagram: do you attach a separate router to act as a switch for your NAS plus other Deco units?
NAS works in Deco but only in AP mode and I want to use the Antivirus and Parental Controls of Deco.
Thanks.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 14095
Replies: 5
Voters 0
No one has voted for it yet.