Internal/external port is not in NAT configuration
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Internal/external port is not in NAT configuration
Model :
Hardware Version :
Firmware Version :
ISP :
Hello,
I am using TP-Link TD-W8961N ADSL2 Modem + Router. I was trying to setup port forwarding in NAT configuration.
I couldn't find internal/external port setting up for virtual server instead I found only start and end port for both internal and external network. ie, if I add a port of my internal server that port is exposed to the WAN with the same port number. How can I route to different external port from my internal server.
Due to that, I am unable to map ports to different virtual servers with application running on same port.
Screenshot is attached below.
Please provide me a solution for this.
Hardware Version :
Firmware Version :
ISP :
Hello,
I am using TP-Link TD-W8961N ADSL2 Modem + Router. I was trying to setup port forwarding in NAT configuration.
I couldn't find internal/external port setting up for virtual server instead I found only start and end port for both internal and external network. ie, if I add a port of my internal server that port is exposed to the WAN with the same port number. How can I route to different external port from my internal server.
Due to that, I am unable to map ports to different virtual servers with application running on same port.
Screenshot is attached below.
Please provide me a solution for this.