VR600 Port forwarding from different machines in the network
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VR600 Port forwarding from different machines in the network
Model :
Hardware Version :
Firmware Version :
ISP :
With my current Speedport ISP router I can assign the same port in port forwarding from any IP in my network, same with my older Linksys router.
I bought the VR600 and found out that this is not possible??
What I can do with my current router is the following
PS3 on 192.168.100.33 open UDP and TCP ports 3478-3479 and 3478-3480 for example
PS4 on 192.168.100.34 open the same ports as above
PC1 at 192.168.100.10 open TCP and UDP port 3290
PC2 at 192.168.100.11 open TCP and UDP port 3290.
On the VR600 I can open only the ports of 192.168.100.33 and 192.168.100.10. If I try to add the 100.34 ports and 100.11 ports I am receiving an error that these are already in use. Any solutions?
Hardware Version :
Firmware Version :
ISP :
With my current Speedport ISP router I can assign the same port in port forwarding from any IP in my network, same with my older Linksys router.
I bought the VR600 and found out that this is not possible??
What I can do with my current router is the following
PS3 on 192.168.100.33 open UDP and TCP ports 3478-3479 and 3478-3480 for example
PS4 on 192.168.100.34 open the same ports as above
PC1 at 192.168.100.10 open TCP and UDP port 3290
PC2 at 192.168.100.11 open TCP and UDP port 3290.
On the VR600 I can open only the ports of 192.168.100.33 and 192.168.100.10. If I try to add the 100.34 ports and 100.11 ports I am receiving an error that these are already in use. Any solutions?