Hard wired terminal on a TPWR802N to establish

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Hard wired terminal on a TPWR802N to establish

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hard wired terminal on a TPWR802N to establish
Hard wired terminal on a TPWR802N to establish
2018-02-25 18:20:14
Model :

Hardware Version :

Firmware Version :

ISP :

Hello
My question is probably naive:

I want to associate several terminals on a local network (no need for internet access)

One of these terminals shall be hard-wired (no wifi capability), the others being wifi-capable (laptop /tablets)

Is it possible to use a single nano router to establish such a network , the hard wired guy connected to the LAN/WAN port. I suspect this is impossible (if the nano router is set in router mode, then only a WAN access can be attached to the physical RJ-45 port.

Am I right or not?

Thanks for your help
  0      
  0      
#1
Options
2 Reply
Re:Hard wired terminal on a TPWR802N to establish
2018-03-09 18:34:08
You're right, there is only one Ethernt port, and that will be WAN port when it's on Rotuer mode, so cannot connect to a client device by cable. You can use TL-WR810N, it has two Ethernet ports.
  0  
  0  
#2
Options
Re:Hard wired terminal on a TPWR802N to establish
2018-03-10 05:32:49
Thank you :-)
  0  
  0  
#3
Options