Archer VR900v1 Regular "lockups" with 'internal error 1' reported on admin console

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer VR900v1 Regular "lockups" with 'internal error 1' reported on admin console

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR900v1 Regular "lockups" with 'internal error 1' reported on admin console
Archer VR900v1 Regular "lockups" with 'internal error 1' reported on admin console
2018-01-28 00:56:41
Model : Archer VR900

Hardware Version :

Firmware Version : 0.9.1 1.5 v004c.0 Build 170119 Rel.66992n

ISP : PlusNet (UK)

Hi,

I've had this VR900 on an ADSL2+ service for quite some time with few, if any, issues.

Now, I'm regularly having to reboot the device as I lose all internet comms. Logging into the admin console (before a reboot) I often see a sluggish response from the pages followed by an 'internal error 1' pop-up.

On firmware 0.9.1 1.5 v004c.0 Build 170119 Rel.66992n since it's release last year.

After the last lock up, I have re-installed the firmware and so far so good, but that was only 6 hours ago, so still early days.

Anyone else experiencing issues with this device/firmware?

Would a change of broadband provider make a difference (moved from Sky to Plusnet about 2 months ago here in the UK, though the issues have only just started to happen in the last couple of weeks)?



Cheers


Neil
  0      
  0      
#1
Options
1 Reply
Re:Archer VR900v1 Regular "lockups" with 'internal error 1' reported on admin console
2018-02-07 06:20:33
Hi Neil,

Contact TP-Link support (support.uk@tp-link.com) and request a beta firmware for VR900 v1
I requested a beta for IPv6 configuration on BT and they sent me
Firmware Version:0.9.1 1.5 v004c.0 Build 170417 Rel.37627n
When you upload the new firmware, because it is a beta version, the administration login address will change to 192.168.1.1
Good luck!:cool:

If you want IPv6 to work with PlusNet (BT) use the following settings with the beta firmware.
[COLOR=#333333][FONT=Arial]Use the following configuration settings (I used these on VR900v1 to get IPV6 to work):-

[/FONT]
[FONT=Arial]BT DNS servers are:-

Primary: 81.139.57.100
Secondary: 81.139.56.100
[/FONT]
[FONT=Arial]Advanced/Network/Internet

Modify/Edit connection
Enable IPV6
Address type: DHCPv6
IPV6 gateway: Current connection
OK
Advanced/Network/LAN Settings
IPV6
RADVD
Delegated
Save


[/FONT]
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 792

Replies: 1

Related Articles