New port assigned for "Web Management Port" not taking effect. and port 80 port forwarding failure.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
New port assigned for "Web Management Port" not taking effect. and port 80 port forwarding failure.
Model :
Hardware Version :
Firmware Version :
ISP :
Hello,
I wanted to forward port 80 to access my Apache server. After I got to know the reason for Error message about port conflict, I changed "Web Management Port" from port 80 to 8095. And I was even able to save the settings of forwarding port 80 under "Virtual servers" and I also saved the new Web Management Port. Then I tried rebooting the device by pressing "On/Off" power button, and switching on after some time. I tried the alternative, "System tools -> Reboot -> reboot button". But after rebooting, I'm logging in again using port 80 but not port 8095 and when I tried the status of forwarding port 80 in this website, I'm getting " Problem! I could not see your service on 103.228.222.40 on port ( 80). Reason: No route to host. "
Now I have one main issue.
1. Why the new port for remote management is not taking effect. I hope, if this setting applies successfully, even forwarding port 80 will be successful.
Thank you.
Hardware Version :
Firmware Version :
ISP :
Hello,
I wanted to forward port 80 to access my Apache server. After I got to know the reason for Error message about port conflict, I changed "Web Management Port" from port 80 to 8095. And I was even able to save the settings of forwarding port 80 under "Virtual servers" and I also saved the new Web Management Port. Then I tried rebooting the device by pressing "On/Off" power button, and switching on after some time. I tried the alternative, "System tools -> Reboot -> reboot button". But after rebooting, I'm logging in again using port 80 but not port 8095 and when I tried the status of forwarding port 80 in this website, I'm getting " Problem! I could not see your service on 103.228.222.40 on port ( 80). Reason: No route to host. "
Now I have one main issue.
1. Why the new port for remote management is not taking effect. I hope, if this setting applies successfully, even forwarding port 80 will be successful.
Thank you.
