Home

Forums

Stories

Knowledge Base

Home Network Community > Powerline Adapters > which is correct type of PLC for IP CCTV cameras

< Powerline Adapters

which is correct type of PLC for IP CCTV cameras

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

which is correct type of PLC for IP CCTV cameras

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

clickclick

2017-09-08 09:15:46

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2017-09-08

which is correct type of PLC for IP CCTV cameras

2017-09-08 09:15:46

Model :

Hardware Version :

Firmware Version :

ISP :

Hi people.

I have not used PLC devices before , can i be advised which are the most reliable devices that will not go into standby / powersaving mode when used with IP cameras ?

I have 150 metres of power cable where i will have 2 IP cameras at one end and the NVR at the other .

which 2 port devices can maintain the connection 100 % reliably ?

3 Reply

Enson Loo

LV4

2017-09-08 10:13:24

Posts: 663

Helpful: 29

Solutions: 0

Stories: 0

Registered: 2017-06-28

Re:which is correct type of PLC for IP CCTV cameras

2017-09-08 10:13:24

The standy mode on the PLC devices can be turn off through the tpPLC utility. You can find the utility on TP-LINK websites.

Peter M

LV4

2017-09-12 17:30:02

Posts: 424

Helpful: 17

Solutions: 0

Stories: 0

Registered: 2016-02-19

Re:which is correct type of PLC for IP CCTV cameras

2017-09-12 17:30:02

Powersaving mode is entered only if the connected device drops its LAN connection - in other words, only if and when the connected device enters its own standby mode AND this standby mode is not a form of "connected standby", like a PC with wake-on-LAN capability. The LAN port on the connected device needs to be truly off for PLC powersave mode to happen.

The Vogon

LV3

2017-09-18 05:33:34

Posts: 183

Helpful: 6

Solutions: 0

Stories: 0

Registered: 2016-12-28

Re:which is correct type of PLC for IP CCTV cameras

2017-09-18 05:33:34

The answer would more likely depend on how many cameras / what resolution and capture rate - i.e. how total much bandwidth you are going to need. If cost is not an issue best to get the fastest (9020 range) - and update to the 3.2.4 firmware (they are not stable with the currently shipping version). I run 4 x 3MP Axis cameras at 20fps / minimum compression (~ 8MB/s) without issue on those across a fairly large house and have bandwidth to do other things as well.

which is correct type of PLC for IP CCTV cameras

which is correct type of PLC for IP CCTV cameras

Information

Voters 0

Tags