Access Points
The Access Point products are mainly designed to establish a wireless network, and, with multiple working modes, you can also expand your existing wireless network or provide internet access to your wired only devices. In this section you can say hello to other members, ask, answer or discuss technical topics regarding Access Points.
Access Points
PLEASE IGNORE THE MODEL SELECTION - I HAD TO CHOOSE ONE AND MY WIRELESS AP WAS NOT ON THE LIST I've just installed a TL-WA1201 wireless AP into my home network and wish to use it's multi-ssid feature
Highlighted ThreadMulti-SSIDNetwork Connectivity
By
DrKalvin
· Latest post 2025-02-08 18:00:06
by Fahimnepal
34Helpful
34265Views
Hi I have two TL-WA1201 APs. One is in an area where relatively few devices connect and is abolutely fine. The other is in an area where eaily 25 plus devices connect (laptops/ipads/Echos and Particle
Highlighted ThreadNetwork Connectivity
17Helpful
14367Views
I use both Access-Points (AP) TLWA1201 and TL WA1801. Both AP are in multi-SSID mode and connected via LAN to a managed switch. I want to set the LAN connection of the AP to VLAN10. TLWA1801: No probl
Network ConnectivityMulti-SSIDVLAN
1Helpful
179Views
I've just installed a new TL-WA801N Access Point and just want to check if my expectations are too high. Comments are welcome on the below information. I'm "feeding" it on a LAN that's pulling from an
Network Connectivity
1Helpful
86Views
The SNMP byte counter for eth0 RX (OID: 1.3.6.1.2.1.2.2.1.10) appears to be inaccurate. For example, the counter value after reset for 1.3.6.1.2.1.2.2.1.10.2 is 926,851,356 (approximately 900 MB), whe
Network Connectivity
By
JayWatanabe
· Latest post 2025-01-23 19:27:31
by jenifferjackson
0Helpful
307Views
Hello, my TP link does not connect to my sky internet, it normally does a flah on the power LED, then middle and wifi LED and then solid lights for about 10 seconds then the middle light drops out and
Network Connectivity
0Helpful
254Views
I just purchased a TL-WA1201 AP and found out that is has no MAC whitelist filtering but a total unusable blacklist!!! What a stupid idea! Blacklist it totally unusable. I can't blacklist unknown MAC'
Network Connectivity
0Helpful
402Views
I bought the TL-WA1201 to use it in a place where there's no power supply. It came with a PoE injector. I am using a 20m CAT6 Ethernet cable and the PoE injector. Problem is that it boots as soon as I
Network ConnectivityInstallationPoE
2Helpful
557Views
Lately, my TL-WA901ND access point requires frequent reboots to allow devices to reconnect. I've set it up to be powered by the POE injector, so I simply unplug the Ethernet cable, reinsert the cable,
Network Connectivity
0Helpful
335Views
Hi, I have setup my TL-WA1201 in Access Point mode, setup a static IP address for device, and enabled DHCP with the correct range and DNS servers. Devices that connect to the access point can easily a
Network Connectivity
By
dr_binks
· Latest post 2024-08-12 14:05:36
by rautshankar672
0Helpful
833Views