Deco
All, I have been using DSL in my rural community with my 7 DECO Mesh UNits for a couple years - ZERO PROBLEMS - I love them! As you can imagine - DSL is very slow - 25 MB Down and 3 UP. We just instal
StarlinkConnection PreferenceNetwork Connectivity
1Helpful
94Views
A few months ago,the latest addition to the Starlink family, known as the Starlink Standard (Gen 3) was released. Over the past few weeks, we've received some inquiries about using Deco with the new S
InstallationOfficialStarlink
1Helpful
4011Views
Hello, I'm using Starlink as my ISP and have it in bypass mode (Ping at 99.87% and almost no outages for over 0.1s) and connected a Deco X50 directly to it (hardwired of course). And set 2 other deco'
StarlinkNetwork ConnectivityDeco EasyMesh
0Helpful
94Views
Set up is Starlink with 2 Deco x68's. Starlink in bypass to use deco in home, connected to separate building (garage) by cat 6 cable. Flawless until the last week when deco kept disconnecting. Happeni
Network ConnectivityStarlink
0Helpful
160Views
Hi everyone, I live in Belgium, in an area with no cellular reception (no Edge/3G/4G). To solve this, I installed a Starlink antenna on my garden shed since my house is surrounded by trees. I have the
StarlinkInstallationNetwork ConnectivityConnection Preference
By
jo-hoendersveld
· Latest post 2024-08-29 02:50:58
by David-TP
0Helpful
371Views
Hi All, A really weird situation here. I have a bunch of Decos around the house all wired in via the ethernet port. They are connected to a Starlink modem and the modem is set to passive, the Decos ar
Deco Ethernet BackhaulStarlinkNetwork Connectivity
0Helpful
362Views
I have been using my Deco mesh with a landline connection to the internet. Now I have Gen 3 Starlink for speed and reliability. I hoped a simple ethernet connect to one of the Deco hubs would work smo
Network ConnectivityStarlinkConnection PreferenceGen3
3Helpful
565Views
Hi, I have a Starlink internet solution and want to use the Decos to get a better signal around the house. I've set up the first Deco via the app a whilst connected it via ethernet to my Starlink rout
Network ConnectivityInstallationStarlink
0Helpful
225Views
Hi, I have three Deco PX50's working with Starlink (with the Starlink router in bypass mode). All of my devices except the "main" Deco show PCL is being used via the Deco app. The device without PCL i
Starlinkpx50
By
thelinkuser
· Latest post 2024-02-20 22:57:12
by Alexmesh
0Helpful
1372Views
Short: I think I need to switch the main Deco to AP mode, but I welcome any corrections, insights or additional info Setup: Have Starlink (gen 2 w/ethernet adapter) and local ISP ADSL line (rj45 comin
VLAN/IPTVAccess Point ModeNetwork ConnectivityStarlink
1Helpful
563Views