BE550 Connection to the Internet when a VPN client is enabled
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I just purchased the BE550 router which I updated to the latest firmware version, in the router I configured a connection to the VPN of my company from which I have no internet access so when I have it enabled I have no internet access, my question is how can I configure the router so that all traffic to the internet goes directly and not through the VPN? On my Mac I have configured in the hosts file the ips that I access from my company.
Thanks
In my house I have the following configuration:
Local network: 192.16.0.0 -> 255.255.255.255.0
Internet provider network -> 192.168.1.0 -> 255.255.255.255.0
Normally when I access the internet the following steps are performed:
A) Local Router - BE550(192.168.0.1) -> Internet Provider Modem (192.168.1.1) -> Internet
When I enable my company's VPN on the router, a new network is generated:
My company network: 10.242.6.0 -> 255.255.255.255.0.
It turns out that when I connect to the VPN the traffic to the internet is already through my company's network, that is:
B) Local Router - BE550(192.168.0.1) -> My company network - VPN (10.242.6.1) -> Internet.
But in the company network there is no way out to the internet.
My concern is if there is a way to configure the router so that when the VPN is enabled, by default the output to the internet is not done through the VPN, but through the modem of the internet provider (A) and so I can manually configure in the routing table that goes to the VPN of my company.
I hope I have been clear.
Thank you very much