Slave will not connect.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2020-03-22 16:51:02

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-03-22

Slave will not connect.

2020-03-22 16:51:02

Model: Deco M4

Hardware Version: V2

Firmware Version:

When I try to connect my slave is the led red and not blue.
what Can I do?

1 Reply

2020-03-23 06:37:32

Posts: 21605

Helpful: 5053

Solutions: 2546

Stories: 21

Registered: 2018-12-24

Re:Slave will not connect.

2020-03-23 06:37:32

With the slave Deco powered on, hold on the reset hole for 1s. Then you can set it up via the Deco app.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.