reset PA8010P to factory default

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2020-03-17 10:21:14

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-03-17

reset PA8010P to factory default

2020-03-17 10:21:14

Model: TL-PA8010P KIT

Hardware Version: V2

Firmware Version: 2.2.3.32-00_801192_170511_906

Made a mistake by changing het ip adres.

I know it stil but I cannot acces the base device anymore.

reset factory does not work. Plaase help.

TPplc seems not to work also older versions not.

reg leon

1 Reply

2020-03-18 09:34:06

Posts: 21611

Helpful: 5056

Solutions: 2549

Stories: 21

Registered: 2018-12-24

Re:reset PA8010P to factory default

2020-03-18 09:34:06

Hi Leo, with the TL-PA8010Pkit powered on, press and hold the pair button for more than 6 seconds to reset the powerline adapter.

Then you can use the tpPLC utility to re-pair them.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.