@schn3id3r Apple doesn't support 320Mhz which is Wifi7 specification. You might have to set the 6Ghz width to max 160Mhz....

@MEM115 Archer defaults to 320 Mhz channel width on the 6 Ghz network which is only supported by WiFi 7. Lower it to 20/40/80/160 Mhz width to be compatible with WiFi 6e.

@el_pablo Don't know about Deco, I have BE800 and BE550, Archer models do not support MLO in easymesh (yet). The BE800 only just recently got tri band MLO feature, probably be a while before mesh is...

@ALi3nW3rX Try disabling all your browser plugins on the router page.

@usslindstrom Is the L3 side of the blue line an IP on the TP Link subnet? Do you only have a static route on the L3 for the TP Link subnet? What happens if you add default route (0.0.0.0) on the L3...

@usslindstrom Consumer routers only have the ability for a single vlan. You would have to have a nic on the TP-Link subnet and set up default route to send traffic to that interface, then it would...