apila22LV1Online
Following: 0Followers: 0
Forums/ Wi-Fi Routers
a week ago
Re:BE550 6Ghz network not showing on Windows
@MEM115 Archer defaults to 320 Mhz channel width on the 6 Ghz network which is only supported by WiFi 7. Lower it to 20/40/80/160 Mhz width to be compatible with WiFi 6e.
0HELPFULS
Forums/ Wi-Fi Routers
a week ago
Re:Connect two Archer BE9300 units together with wired backhaul to form easy mesh network with MLO?
@el_pablo Don't know about Deco, I have BE800 and BE550, Archer models do not support MLO in easymesh (yet). The BE800 only just recently got tri band MLO feature, probably be a while before mesh is...
0HELPFULS
Forums/ Wi-Fi Routers
a week ago
Re:No VPN Client button to turn on/off vpn client.
@ALi3nW3rX Try disabling all your browser plugins on the router page.
0HELPFULS
Forums/ Wi-Fi Routers
2 weeks ago
Re:Additional NAT Networks
@usslindstrom Is the L3 side of the blue line an IP on the TP Link subnet? Do you only have a static route on the L3 for the TP Link subnet? What happens if you add default route (0.0.0.0) on the L3...
0HELPFULS
Forums/ Wi-Fi Routers
2 weeks ago
Re:Additional NAT Networks
@usslindstrom Consumer routers only have the ability for a single vlan. You would have to have a nic on the TP-Link subnet and set up default route to send traffic to that interface, then it would...
0HELPFULS
Forums/ Wi-Fi Routers
2 weeks ago
Re:How to get Wi-Fi from my house to my barn
@redwagon Setup both CPE210 in your house first to make sure they connect. The AP mode (not AP router mode) connects to the Deco LAN port via the PoE adapter. Move the client mode (not AP client...
0HELPFULS
12