I have a network of 3 Archer C4000 and 6 Archer A7. All of the routers are connected by CAT6 cable. The home router is a C4000 v3.0 with the latest firmware (as are the A7s). Is there a way to record
By
bevelsport
· Latest post 11 minutes ago
0Helpful
5Views
The usb port on the main Deco unit works just fine. However, whenever I plug a portable ssd into the usb port of a satellite deco unit, it quickly turns red and stops working. Please let me know how t
By
sachdsk
· Latest post an hour ago
0Helpful
11Views
I bought a TL-WA1201 to work as an AP. It's was set up fine and appeared to be working both in 2.4 and 5Ghz. But not i have many devices connecting to on 2.4 which now say connected by no Internet. If
By
Slothy811l
· Latest post 15 hours ago
0Helpful
14Views
Please help: I just tried to enter the device config and it does not work. I reset the device by pressing the back button and same thing. TL-SG108E came with a simple manual it says that config is at
By
WhatsAppJack
· Latest post 20 hours ago
0Helpful
24Views
Hello, I just set the Decos up this morning, and since then I am experiencing disconnection periods, and some latency variations. Those problems even occur when I'm connected to my ISP router, as long
Access Point Mode
1Helpful
30Views
this thing is the biggest POS I've ever used. do not buy unless you enjoy constantly dropping and having to reconfigure. f tplink forever.
By
fklink
· Latest post Yesterday
1Helpful
29Views
So I've had a stable setup going on for quite a while now. Very recently my whole home network went down. I was sure it was my Xfinity ISP service, however I noticed that I had no LAN connections work
0Helpful
59Views
Hi all, I have a small business where I use a service called AudioFetch. For those not familiar with it, it is a device which is fed an audio feed and it streams it over an app to devices on a local n
Client DevicesRoaming
0Helpful
38Views
Hello, How do I change the default LAN IP address on my AX55 Pro from 192.168.0.1 to 192.168.3.xxx? any and help is appreciated in advance.
Feature Request
0Helpful
35Views