Any TP-Link Omada Experts Any Omada Experts, I’m struggling to configure secure VLAN ACLs on my TP-Link Omada setup (ER605 router, TL-SG2016P loft switch, TL-SG2218P office switch, OC200 controller) t

Daily disconnection ER605 My configuration: Netgear LB1110 LTE (configured as a modem), gateway ER605 V2 2.2.6 (Build 20240718 Rel.82712), switch TL-SG2428P, 2 EAP225 and the Omada software controller

It would be great to have a feature (as exists on other platforms) that provides an internal (LAN side) virtual NAT, to allow one IP address to exist as virtual IPs on other vlans eg: Say i have a pri

If you manage a number of remote sites, and have complicated access rules between the vlans at each remote sites and your main site, you can quickly run out of useable IP Groups and IP-Port Groups, as

Migrating to OPNSense router, and limited ports. Current setup OC200 is connected to router, but no available port on the OPNSense box. Am I setting myself up for problems if the OC200 is connected to

This guide is for advanced users! How to enable split-switch routing per vlan, with seperate DHCP pools for end clients depending on use case General Overview Prerequisites: - Omada Router - At least