I have 2 vlans configured. 1 on port 3 (vlan2) and 1 on port 6 (vlan4) both have separate subnets assigned with dhcp enabled, but for some reason the device connected to ports 3 and 6 are still gettin

I'm a little bit stuck what I'm trying to do is put all my IOT devices into the IOT VLAN through a separate WIFI network and dedicated ports on my switch: TL-SG2008P v1.0 but I can't seem to figure ou

I m trying to create a voice vlan for a static ip using the omada controler but the guide in the site can't help me because I can't find a QOS tab in the controler pages. Till this point I have done t

I'm using the Omada SDN Cloud, with compatible gateway, Switch, and several access points. However, since a few days back one of my access points has reported a status of "Isolated" and I can't seem t

Just received the TL-ER7206 to replace a non-omada router in my existing SDN network. I am running the latest controller and firmware, and my native network is 192.168.68.0/24. Trying to adopt the rou

I have six EAP245 V3 and two EAP225-outdoor. All EAP245 work completely fine with my POE switch (CRS328, supports 802.3AF, 802.3AT, passive poe) but none of the eap225 will power on without the switch