@tdoe321 You should be able to do that via a web browser on a computer in your local network. 1.Visit http://tplinkrepeater.net, and log in with your TP-Link ID or the password you set for the...

@Sabith Did you try to reset the RE to its factory defaults ? If not - press and hold the reset button for about 10 seconds then test again. If your RE still doesn't work then contact your retailer...

@Dinis124 Revert your REs to their latest FW release (v1.0.13) and try setting a static IP addresses for the REs preferably outside of your router DHCP pool and test how it goes. These REs should...

@tdoe321 " Due to changes in default gateway settings, the feature of port forwarding has been enabled " " Due to changes in default gateway settings, the feature of port forwarding rules has been...

@rene122024 If not using MTU VLANs any port can be an unplink port. Check the switch use guide - here (page 58). I beleive your printer should negotiate 100MF (Link Status:100Full) with TL-SG608E....

@tapac3 Here's the official procedure for recovery from a bricked router. I believe that C64 should be the Case 1 from this guide. If that doesn't work for you try the suggestions from this thread.