@peter021 Sorry no, the only TPLink employees that regularly post here are Fae and Hank.

@surfer1 The easy way I think of it is that the PVID is used to associate a VLAN to the incoming untagged packets, and the Untagged VLAN setting is to identify outgoing untagged packets. So a packet...

@ErwinvL Good to hear you found the issue and that a simple server reboot has fixed it. That's some great packet sniffing.

@mehmeh Just some thoughts that may or may not work. While a bit intensive, have you tried a factory reset on the OC200, and then restore with settings only to the last backup or even full hand input...

@ErwinvL For trouble shooting, you could try to direct connect one of the APs to the router box, and see if the VLANs carry through that simple config. You could also try setting an open port on the...

@AlexS20 Make sure you have good signal strength between the two mesh nodes, should try to get above -60dbi.