I had big problem when I configure AP's to work with oc200 and TL-R605 (using manual IP, mask, gateway and DNS addresses). In this configuration I used tp-link switches but not dedicated for Omada. Wi

I'm a little bit stuck what I'm trying to do is put all my IOT devices into the IOT VLAN through a separate WIFI network and dedicated ports on my switch: TL-SG2008P v1.0 but I can't seem to figure ou

Hello, statistics for devices connected to the LAN switch have stopped being recorded after firmware update. The network has a topology: TL-R605 v1.0 1.0.1 Build 20210113 Rel.35074 TL-SG2008P v1.0 1.0

Programs use specific ports to send or receive data via a network. An Omada software controller or EAP Discovery Utility uses the ports on the host, while an Omada hardware controller uses the ports o

Hi, I'm seeing some pretty high number for a device that definitely doesn't generate this amount of data. This is what I see in Omada: If you compare it to my Prometheus data, it doesn't seem to make

Network has 50 clients with 25 being wired connections. Often 5-10 wired clients are missing from Omada's clients list for hours. The missing clients are connected and using a small amount of bandwidt