Camera was working fine but after the last firmware update which I did on Jan 2019 - which is NC450_v1.5.0_181022

I then noticed frequent disconnections - and it never can display the video feed or am I able to access the camera features through the tpCamera app anymore.

So I decided to reset the camera and tried to setup again. It worked a few times but after a while it would just disconnect and the same problem arises.

Now it's gotten to the point that I can't even setup the camera anymore. Everytime during setup it would be flashing green - and when it is about to turn to a stable green LED just for a second or two, it will turn turn red and spin around again effectively restarting itself everytime!

I have even tried setting it up by plugging directly to the router using an Ethernet cable - and the same thing happens! Just goes green for a while - and then turns red and blinking red then spinning around again.

My main router is a TP Deco M4 on the latest firmware in Malaysia - which I thought should work fine since they are from the same manufacturer.

This makes the whole camera useless.... can someone please help? I really need to get the camera working - and if it's not then I would throw it away and get a new one than wasting my time on this~!