Hello folks I would like to enable spanning tree and link between my two main switches. Currently i have an "Aggregation" switch with a 10gbit link from my ER8411 to my SG3428X From the SG3428X i have

I have an OC200, and about 15 EAP 225's (indoor and outdoor) Some connected via Mesh and some cable. Sometimes several times an hour random devices will disconnect and instantly reconnect. And then so

This Article Applies to ER7206(UN) V2 Release Notes Version Info: Adapted Model: ER7206(UN) V2 Fully Adapted Controller Version: SDNC 5.15.20.X - Omada SDN Controller_V5.15.20.7 Pre-Release Firmware W

Good day, I recently upgraded my router from a TL-ER5120 v3.0 to the ER8411 and have encountered a persistent connectivity issue. The initial setup was stable for a few days, but after approximately o

My equipment: Gateway/Controller/Router: ER7212PC v1.0 Switch: SG2218 v1.20 AP: EAP670(US) v2.0[Custom] Since I applied firmware v1.20.4 to the switch, new devices connected to switch ports can no lon

Can we gen a MAC-Port group in Omada please? For example, lets say i have an Omada switch set up with multiple vlan interfaces. I dont want everyone on all VLANs to be able to even reach the web gui.