Switches SG3452 v1.2 firmware 1.20.3. (released today, dated november) SG3210 v3 firmware 3.20.3 (released today dated november) SG2218P v2 firmware 2.0.0 (factory firmware, no new releases yet)...

@OCasasola When you adopt the router, its settings get reset to whatever is programmed into the controller. If you dont have the router pre-configured (start in settings > wired networks > wan) you...

@downtheroad As i indicated, my 8411 runs a pretty complex network with tons of traffic, IDS turned on, DPI turned on, 3 WANs. Ignore the big spikes, i was configureing some stuff and rebooting - the...

@downtheroad Disconnect your controller form the network. Log into the router GUI directly via its IP (you can only do this with the controller disconnected) Initiate a factory reset from the GUI....

@BCCHowdy Switch ACL rules are not what you want, you want gateway ACL rules. Switch rules are not stateful, therefore thay are unable to account for a situation like Device A cannot access device B,...

@Vincent-TP My OC200 v1 running Nov 8th prerelease rebooted by itself tonight for no reason. I was in the interface looking at data usage graphs and BAM, no response.... I could connect to all other...