Hello everyone, I have a site that has a manually configured ER605 performing load balancing across two WAN networks with an EAP225 connected, also manually configured. I have set the controller infor

Good Morning, I'm hoping someone might be able to assist here. I am managing two sites remotely, both sites are connected via mobile data, so have CG-NAT. There are two sites at the same location, one

Good Afternoon, Hoping someone might be able to assist here. I have a remote Omada setup with an ER605 router and also a similar setup at another site, I've established a site to site VPN between the

Hi all I'm looking to run an external access point ideally in the Omada range that can be driven from 12V. I currently have this set up using an inverter to power the POE, but this is not very efficie

Morning all, I know this question has been asked a million times before, but I've checked and re-checked everything and still the little sucker keeps doing it. I have an OC200 (v4.3.5) that's currentl

Hello, I'm deploying an EAP-225 mesh network, currently it has one gateway to the internet, however I am wondering if I can add another gateway (connected to an EAP225) that is on a totally different