G0tta_be_KDLV1Online
Following: 0Followers: 0
Forums/ Deco
3 weeks ago
Two Deco WE10800 with one Deco X60. The X60 is limited to 100Mbp over a wired backhaul.
I have the following configuration: 2 x Deco WE10800 v2.6 (similar to XE75) - Firmware 1.2.14 Build 20241015 1 x Deco X60 v2 - Firmware 1.5.3 Build 20231227 Internet connection is 500Mbps Main floor...
1HELPFULS
Forums/ Switches
2024-05-09 21:42:05
Re:SG3210X-M2 just magically stopped working this morning
@Schmuckster I'd assume it's still 1.0.1 even if you removed it from the controller. There's no reason for that to downgrade if it's used as a standalone switch. TP-Link indicated to me that they...
0HELPFULS
Forums/ Switches
2024-05-09 21:30:33
Re:SG3210X-M2 just magically stopped working this morning
@Schmuckster That's too bad. Which firmware did you have running on it? It's strange, I was going to box up my switch and send it for RMA, but then decided to test it again. All of a sudden the ports...
0HELPFULS
Forums/ Switches
2024-05-09 19:47:34
Re:SG3210X-M2 just magically stopped working this morning
@Clive_A I was previously connecting directly to the switch to manage it. Last night I setup an Omada Controller and added the switch to it so I could manage it through that. Immediately, I noticed...
0HELPFULS
Forums/ Switches
2024-05-01 07:23:50
Re:SG3210X-M2 just magically stopped working this morning
@Clive_A Just an update, but it seems like my SG3210X-M2 switch is working properly again. I'm not sure what happened, but the only thing that's changed over the past few days is that the Dream...
1HELPFULS
Forums/ Switches
2024-04-28 03:37:02
Re:SG3210X-M2 just magically stopped working this morning
@Clive_A Can you let me know the specific IP address you got from the devices(RJ45)? - The same IP address that was assigned to them when everything was still working. The IP addresses haven't...
0HELPFULS
12