@n0izee I have my OC 200 on its very own, basic TPlink "easy smart" poe switch (SG105PE) with POE recovery set so that if the switch cant ping the IP of the controller on its port, it waits a minute...

@Vincent-TP This latest version on OC200 v1 left my ER8411 in a "Disconnected" state and requiring a power cycle. All other switches and EAPs were re-adopted normally. No WAN settings being wiped...

@Dsunder Yes, i have this issue on my own business network as well. It doesnt effect connectivity at all, and the best i can figure it out is as follows: If every switch has a single link, or a LAG...

@AkoNaNi You need to make an allow rule using IP groups from kids SSID > Controller IP on main LAN, and place it above the deny rule.

@mbentley I would imagine the reason it was taken down entirely was due to the reasons myself and a few others have reported - under some circumstances, it is deleting and resetting WAN port settings...

@Vincent-TP 2 sites. Local site - ER8411 - All OK Remote Site - ER7206 v2 - Wiped WAN settings Edit: the remote site effected is a direct WAN IN communication to the main site with NAT port...